SS-EN-ISO-10350-1-AM1 Historical Revision Information
Plastics - Acquisition and presentation of comparable single-point data - Part 1: Moulding materials (ISO 10350-1:2008/Amd 1:2014)

SS-EN-ISO-10350-1-AM1 - 2008 EDITION AMENDMENT 1 - SUPERSEDED
Show Complete Document History

Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:


ISO 10350 identifies specific test procedures for the acquisition and presentation of comparable data for certain basic properties of plastics. In general, each property is specified by a single experimental value, although in certain cases properties are represented by two values obtained under different test conditions. The properties included are those presented conventionally in manufacturers' data sheets. This part of ISO 10350 applies predominantly to unreinforced and reinforced thermoplastic and thermosetting materials that may be injection- or compression-moulded or prepared as sheets of specified thickness. Part 2 of ISO 10350 deals specifically with long- or continuous-fibre-reinforced plastics. For the purposes of ISO 10350, long-fibre-reinforced plastics are considered to have fibre lengths greater than 7,5 mm prior to moulding.

To find similar documents by classification:

83.080.01 (Plastics in general)

83.080.20 (Thermoplastic materials)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

ORDER



Designation Name

SS-EN ISO 10350-1:2008/A1:2014

Revision Level

2008 EDITION AMENDMENT 1

Status

Superseded

Publication Date

Oct. 29, 2014

Language(s)

English

Page Count

8

International Equivalent

EN ISO 10350-1:2008/A1:2014(IDT); ISO 10350-1:2007/Amd 1:2014(IDT)