SS-EN-ISO-10683 › Fasteners - Non-electrolytically applied zinc flake coatings (ISO 10683:2018)
Show Complete Document History
The following bibliographic material is provided to assist you with your purchasing decision:
This document specifies requirements for non-electrolytically applied zinc flake coating systems for steel fasteners. It is applicable to coatings: with or without hexavalent chromium; with or without top coat; with or without lubricant (integral lubricant and/or subsequently added lubricant). It is applicable to bolts, screws, studs and nuts with ISO metric thread, to fasteners with non-ISO metric thread, and to non-threaded fasteners such as washers, pins, clips, etc. This document does not specify requirements for such fastener properties as weldability or paintability. It is not applicable to mechanically applied zinc coatings. NOTE Coatings in accordance with this document are especially used for high strength fasteners (≥ 1 000 MPa) to avoid risk of internal hydrogen embrittlement (IHE see 4.4). Information for design and assembly of coated fasteners is given in Annex A.
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
SS-EN ISO 10683:2018
Sept. 25, 2018
EN ISO 10683:2018(IDT); ISO 10683:2018(IDT)