SS-EN-ISO-13704 › Petroleum, petrochemical and natural gas industries - Calculation of heater-tube thickness in petroleum refineries (ISO 13704:2007)
The following bibliographic material is provided to assist you with your purchasing decision:
Included in this current edition are the following subparts:
2007/AC:2009 EDITION CORRIGENDUM - June 15, 2009
This International Standard specifies the requirements and gives recommendations for the procedures and design criteria used for calculating the required wall thickness of new tubes and associated component fittings for petroleum-refinery heaters. These procedures are appropriate for designing tubes for service in both corrosive and non-corrosive applications. These procedures have been developed specifically for the design of refinery and related process-fired heater tubes (direct-fired, heat-absorbing tubes within enclosures). These procedures are not intended to be used for the design of external piping. This International Standard does not give recommendations for tube retirement thickness; Annex A describes a technique for estimating the life remaining for a heater tube.
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
SS-EN ISO 13704:2007
Nov. 26, 2007
EN ISO 13704:2007(IDT); ISO 13704:2007(IDT)