SS-EN-ISO-14120 › Safety of machinery - Guards - General requirements for the design and construction of fixed and movable guards (ISO 14120:2015)
The following bibliographic material is provided to assist you with your purchasing decision:
Included in this current edition are the following subparts:
2018 EDITION - Nov. 26, 2015
This International Standard specifies general requirements for the design, construction, and selection of guards provided to protect persons from mechanical hazards.This International Standard indicates other hazards that can influence the design and construction of guards.This International Standard applies to guards for machinery which will be manufactured after it is published.The requirements are applicable if fixed and movable guards are used. This International Standard does not cover interlocking devices. These are covered in ISO 14119.This International Standard does not provide requirements for special systems relating specifically to mobility such as ROPS (rollover protective structures), FOPS (falling-object protective structures), and TOPS (tip over protective structures) or to the ability of machinery to lift loads.
To find similar documents by classification:
Revised Machinery Directive
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
SS-EN ISO 14120:2018
Nov. 26, 2015
EN ISO 14120:2015(IDT); ISO 14120:2015(IDT)