SS-EN-ISO-14253-1 Geometrical product specifications (GPS) - Inspection by measurement of workpieces and measuring equipment - Part 1: Decision rules for verifying conformity or nonconformity with specifications (ISO 14253-1:2017)

SS-EN-ISO-14253-1 - 2017 EDITION - CURRENT
Show Complete Document History

Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:

This document establishes the rules for verifying the conformity or nonconformity with a given tolerance for a characteristic of a workpiece (or a population of workpieces) or with a given maximum permissible errors for a metrological characteristic of a measuring equipment, including when the measured value falls close to the specification limits, taking measurement uncertainty into account. This document applies to specifications defined in general GPS standards (see ISO 14638), i.e. standards prepared by ISO/TC 213, including: — workpiece specifications and population specifications (usually given as an upper specification limit or a lower specification limit or both); — measuring equipment specifications (usually given as maximum permissible errors). This document only applies for characteristics and maximum permissible errors expressed as quantity values.

To find similar documents by classification:

17.040.01 (Linear and angular measurements in general)

17.040.40 (Geometrical Product Specification (GPS))

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.




Designation Name

SS-EN ISO 14253-1:2017

Revision Level




Publication Date

Dec. 13, 2017



Page Count


International Equivalent

EN ISO 14253-1:2017(IDT); ISO 14253-1:2017(IDT)