SS-EN-ISO-15530-3 Geometrical product specifications (GPS) - Coordinate measuring machines (CMM): Technique for determining the uncertainty of measurement - Part 3: Use of calibrated workpieces or measurement standards (ISO 15530-3:2011)

SS-EN-ISO-15530-3 - 2011 EDITION - CURRENT


Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:


This part of ISO 15530 specifies the evaluation of measurement uncertainty for results of measurements obtained by a CMM (coordinate measuring machine) and by using calibrated workpieces or measurement standards. It provides an experimental technique for simplifying the uncertainty evaluation of CMM measurements, whose approach (substitution measurements) leads to measurements being carried out in the same way as actual measurements, but with calibrated workpieces of similar dimension and geometry instead of the unknown workpieces to be measured. Non-substitution measurements on CMMs are also covered, as are the requirements of the uncertainty evaluation procedure, the measurement equipment needed, and the reverification and interim check of the measurement uncertainty. NOTE The evaluation of measurement uncertainty is always related to a specific measuring task.

To find similar documents by classification:

17.040.30 (Measuring instruments)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

ORDER

Price:

$128.58        




Designation Name

SS-EN ISO 15530-3:2011

Revision Level

2011 EDITION

Status

Current

Publication Date

Oct. 31, 2011

Language(s)

English

Page Count

32

International Equivalent

EN ISO 15530-3:2011(IDT); ISO 15530-3:2011(IDT)