SS-EN-ISO-15646 › Re-sintering test for UO2, (U,Gd)O2 and (U,Pu)O2 pellets (ISO 15646:2014)
The following bibliographic material is provided to assist you with your purchasing decision:
This International Standard describes a procedure for measuring the densification of UO2, (U,Gd)O2, and (U,Pu)O2 pellets, achieved by heat treatment under defined conditions.The densification of fuel in power operation is an important design feature. Essentially, it is dependent on structural parameters such as pore size, spatial pore distribution, grain size, and in the case of (U,Gd)O2 and (U,Pu)O2, oxide phase structure. A thermal re-sintering test can be used to characterize the dimensional behaviour of the pellets under high temperature. The results of this test are used by the fuel designer to predict dimensional behaviour in the reactor, because thermal densification in the reactor is also dependent on these structural parameters, albeit in a differing manner in terms of quantity.On the assumption of the prediction, it is necessary to correlate the results of this test by some correlation rules, because the results of this test vastly depend on the re-sintering conditions (such as heat treatment temperature, treatment time, gas content, and partial oxygen pressure).
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
SS-EN ISO 15646:2016
April 25, 2016
EN ISO 15646:2016(IDT); ISO 15646:2014(IDT)