SS-EN-ISO-15876-2 Plastics piping systems for hot and cold water installations - Polybutylene (PB) - Part 2: Pipes (ISO 15876-2:2003)

SS-EN-ISO-15876-2 - 2004 EDITION - CURRENT
Show Complete Document History

Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:

Included in this current edition are the following subparts:

 2004 EDITION - Jan. 9, 2004
 2017 EDITION - Feb. 14, 2017

This Part of EN ISO 15876 specifies the characteristics of pipes made of polybutylene (PB) for piping systems intended to be used for hot and cold water installations within buildings for the conveyance of water whether or not intended for human consumption (domestic systems), and for heating systems, under design pressures and temperatures appropriate to the class of application (see Table 1 of EN ISO 15876-1:2003). This standard covers a range of service conditions (application classes), design pressures and pipe dimension classes. For values of TD, Tmax and Tmal in excess of those in Table 1of Part 1, this standard does not apply. NOTE 1 It is the responsibility of the purchaser or specifier to make the appropriate selections from these aspects, taking into account their particular requirements and any relevant national regulations and installation practices or codes. It also specifies the test parameters for the test methods referred to in this standard. In conjunction with the other Parts of EN ISO 15876 (see Foreword) it is applicable to PB pipes, their joints and to joints with components of PB, other plastics and non-plastics materials intended to be used for hot and cold water installations. It is applicable to pipes with or without (a) barrier layer(s). NOTE 2 In the case of plastics pipes provided with a thin barrier layer, e.g. to prevent or greatly diminish the diffusion of gases and the transmission of light into or through the pipe wall and where the design stress requirements are totally met by the base polymer (PB).

To find similar documents by classification:

23.040.01 (Pipeline components and pipelines in general)

23.040.20 (Plastics pipes)

91.140.60 (Water supply systems Including water meters in buildings External water conveyance systems, see 93.025)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

ORDER

Price:

$247.40        




Designation Name

SS-EN ISO 15876-2:2004

Revision Level

2004 EDITION

Status

Current

Publication Date

Jan. 9, 2004

Language(s)

English

Page Count

17

International Equivalent

EN ISO 15876-2:2003(IDT); ISO 15876-2:2003(IDT)