SS-EN-ISO-17852 › Water quality - Determination of mercury - Method using atomic fluorescence spectrometry (ISO 17852:2006)
The following bibliographic material is provided to assist you with your purchasing decision:
This International Standard specifies a method for the determination of mercury in drinking, surface, ground andrain water using atomic fluorescence spectrometry.NOTEThis International Standard may be applied to industrial and municipal waste water after an additional digestion stepunder appropriate conditions.The potential linear dynamic range is approximately to . In practice, the working range is oftenfrom to .Samples containing mercury at concentrations higher than the working range can be analysed followingappropriate dilution of the sample.The method detection limit () will be dependent on the selected operating conditions and calibration range.With high purity reagents, a of less than is obtainable.The relative standard deviation is typically less than for concentrations greater than twenty times themethod detection limit.The sensitivity of this method is dependent on the selected operating conditions.
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
SS-EN ISO 17852:2008
Jan. 21, 2008
EN ISO 17852:2008(IDT); ISO 17852:2006(IDT)