SS-EN-ISO-19065-1 › Plastics - Acrylonitrile-styrene-acrylate (ASA), acrylonitrile-(ethylene-propylene-diene)-styrene (AEPDS) and acrylonitrile-(chlorinated polyethylene)-styrene (ACS) moulding and extrusion materials - Part 1: Designation system and basis for specifications (ISO 19065-1:2014)
The following bibliographic material is provided to assist you with your purchasing decision:
This part of ISO 19065 establishes a system of designation for acrylonitrile-styrene-acrylate (ASA), acrylonitrile-(ethylene-propylene-diene)-styrene (AEPDS) and acrylonitrile-(chlorinated polyethylene)-styrene (ACS) moulding and extrusion materials, which may be used as the basis for specifications.1.2 The types of ASA, AEPDS and ACS plastic are differentiated from each other by a classification system based on appropriate levels of the designatory properties:a) Vicat softening temperature,b) melt volume-flow rate,c) Charpy notched impact strength,d) tensile modulus,and on information about composition, intended application and/or method of processing, important properties, additives, colorants, fillers and reinforcing materials.
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
SS-EN ISO 19065-1:2014
Dec. 7, 2014
EN ISO 19065-1:2014(IDT); ISO 19065-1:2014(IDT)