SS-EN-ISO-25137-1 › Plastics - Sulfone polymer moulding and extrusion materials - Part 1: Designation system and basis for specifications (ISO 25137-1:2009)
Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
ISO 25137-1:2009 establishes a system of designation for sulfone polymer moulding and extrusion materials, including polysulfone (PSU), polyethersulfone (PESU) and polyphenylsulfone (PPSU), which may be used as the basis for specifications. The types of sulfone plastic are differentiated from each other by a classification system based on appropriate levels of the designatory properties temperature of deflection under load, melt mass-flow rate, Charpy notched impact strength, tensile modulus and yield stress, and on information about composition, intended application and/or method of processing, important properties, additives, colorants, fillers and reinforcing materials. This part of ISO 25137 is applicable to all sulfone polymers that contain ether oxygen, which is a necessary component of the polymers as in the diphenyl sulfone moiety. It applies to sulfone polymer materials ready for normal use in the form of powder, granules or pellets, unmodified or modified by colorants, additives, fillers, etc.
To find similar documents by classification:
83.080.20 (Thermoplastic materials)
Designation Name
SS-EN ISO 25137-1:2017
Revision Level
REPACD BY SS-EN-ISO-24025-1
Status
Current
Publication Date
June 2, 2020
Language(s)
English
Page Count
24
International Equivalent
EN ISO 25137-1:2017(IDT); ISO 25137-1:2009(IDT)