SS-EN-ISO-4519 Electrodeposited metallic coatings and related finishes - Sampling procedures for inspection by attributes (ISO 4519:1980)


Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:

This International Standard establishes sampling plans and procedures for inspection by attributes of electrodeposited metallic coatings. It may be applied to related finishes by agreement between the supplier and the purchaser. It is based on ISO 2859 (see also Addendum 1 to ISO 2859).The sampling plans in this International Standard are applicable, but not limited, to the inspection of end items, components, materials in process and finished products in storage. The plans are intended primarily to be used for a continuing series of lots, but they may also be used for the inspection of isolated lots. However, the assurance given for isolated lots is lower than that given for a continuing series of lots.This International Standard is not applicable to the sampling and testing of mechanical fasteners having electrodeposited metallic coatings or related finishes, in all the circumstances for which procedures for these components are specified in ISO 3269.The sampling plans given in this International Standard are based on AQLs1) of 1,5 and 4,0 %. Other AQLs may be used if specified in the product specification, in which case reference should be made to ISO 2859 and its Addendum 1.It is also possible to formulate sampling plans based on inspection by variables

To find similar documents by classification:

17.040.20 (Properties of surfaces)

25.220.40 (Metallic coatings Including electrolytic depositions, cathodic coatings, autocatalytic coatings, etc.)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.




Designation Name

SS-EN ISO 4519:2016

Revision Level




Publication Date

April 25, 2016



Page Count


International Equivalent

EN ISO 4519:2016(IDT); ISO 4519:1980(IDT)