SS-EN-ISO-7233 › Rubber and plastics hoses and hose assemblies - Determination of resistance to vacuum (ISO 7233:2016)
Show Complete Document History
The following bibliographic material is provided to assist you with your purchasing decision:
ISO 7233:2016 specifies three methods for determining the resistance to vacuum of hoses and hose assemblies manufactured from plastic or rubber. Applicable dimensions of hoses for each method are as follows: - method A for hoses of nominal bore up to and including 80 mm; - method B for hoses of nominal bore greater than 80 mm; - method C for hoses of all dimensions. Methods A and B can also be used to check the adhesion of the lining to the reinforcement (delamination) in a length of hard-wall hose or hose assembly.
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
SS-EN ISO 7233:2017
Feb. 6, 2017
EN ISO 7233:2016(IDT); ISO 7233:2016(IDT)