SS-EN-ISO-8222 Petroleum measurement systems - Calibration - Temperature corrections for use when calibrating volumetric proving tanks (ISO 8222:2002)

Show Complete Document History

Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:

This International Standard specifies multiplication factors for the correction of the volume of water transferred from a primary measure to a tank for changes arising from temperature differences during the determination of the capacity of the tank at reference temperature. NOTE This International Standard does not set out a calibration procedure nor consider the uncertainties in temperature measurement, for which reference should be made to other standards. Equations are given in annex A for the determination of the density of air-free and air-saturated, pure water in the temperature range 1,0 oC to 40 oC for temperatures expressed in terms of the ITS-90 International Temperature Scale. A calculation routine is also provided in annex B for the combined water and metal correction factor that is applied when determining the capacity of the tank at reference temperature.

To find similar documents by classification:

75.180.30 (Volumetric equipment and measurements)

75.200 (Petroleum products and natural gas handling equipment Including petroleum and natural gas storage devices, distribution systems, pipelines, petrol stations, dispensing devices, etc.)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.




Designation Name

SS-EN ISO 8222

Revision Level




Publication Date

Nov. 22, 2002



Page Count


International Equivalent

ISO 8222:2002 IDT* EN ISO 8222:2002 IDT