SS-EN-ISO-8491 › Metallic materials - Tube (in full section) - Bend test (ISO 8491:1998)
SS-EN-ISO-8491
-
2005 EDITION
-
CURRENT
Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
This International Standard specifies a method for determining the ability of full-section metallic tubes of circular cross-section to undergo plastic deformation in bending. It is intended for tubes with an outside diameter no greater than 65 mm, although the range of the outside diameter for which this International Standard is applicable may be more exactly specified in the relevant product standard. NOTE Bend tests of the test pieces taken from tubes in the form of transverse strips should be made in accordance with ISO 7438 so as to increase the original curvature of the test piece.
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Designation Name
SS-EN ISO 8491:2005
Revision Level
2005 EDITION
Status
Current
Publication Date
Feb. 4, 2005
Language(s)
English
Page Count
6
International Equivalent
EN ISO 8491:2004(IDT); ISO 8491:1998(IDT)