SS-EN-ISO-8503-4 › Preparation of steel substrates before application of paints and related products - Surface roughness characteristics of blast-cleaned steel substrates - Part 4: Method for the calibration of ISO surface profile comparators and for the determination of surface profile - Stylus instrument procedure (ISO 8503-4:2012)
Show Complete Document History
The following bibliographic material is provided to assist you with your purchasing decision:
This part of ISO 8503 specifes the stylus instrument and describes the procedure for calibrating ISO surface profle comparators conforming to the requirements of ISO 8503-1.This part of ISO 8503 is also applicable to the determination of the surface profle, within the range Ry5 = 20 µm to Ry5 = 200 µm, of essentially planar blast-cleaned steel. The determination can be carried out on a representative section of the blast-cleaned surface or, if direct observation of the surface is not feasible, on a replica of the surface (see Annex C).NOTE Where appropriate, this procedure can be used to assess the roughness profle of other abrasive blast-cleaned substrates.An alternative procedure is described in ISO 8503-3.
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
SS-EN ISO 8503-4:2012
March 7, 2012
EN ISO 8503-4:2012(IDT); ISO 8503-4:2012(IDT)