SS-EN-ISO-898-5 Mechanical properties of fasteners made of carbon steel and alloy steel - Part 5: Set screws and similar threaded fasteners with specified hardness classes - Coarse thread and fine pitch thread (ISO 898-5:2012)

Show Complete Document History

Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:

ISO 898-5:2012 specifies mechanical and physical properties of set screws and similar threaded fasteners made of carbon steel or alloy steel when tested at an ambient temperature range of 10 °C to 35 °C. Fasteners (the term used when set screws and similar threaded fasteners are considered all together) which conform to the requirements of ISO 898-5:2012 are evaluated at that ambient temperature range. Fasteners according to ISO 898-5:2012 are classified to specified hardness classes and are intended for use under compressive stress only. ISO 898-5:2012 is applicable to set screws and similar fasteners: made of carbon steel or alloy steel, having a triangular ISO metric screw thread according to ISO 68-1, with a coarse pitch thread M1,6 to M30, and fine pitch thread M8×1 to M30×2, with diameter/pitch combinations according to ISO 261 and ISO 262, and having thread tolerances according to ISO 965-1 and ISO 965-2.

To find similar documents by classification:

21.060.01 (Fasteners in general)

21.060.10 (Bolts, screws, studs)

Pressure equipment

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.




Designation Name

SS-EN ISO 898-5:2012

Revision Level




Publication Date

June 14, 2012



Page Count


International Equivalent

EN ISO 898-5:2012(IDT); ISO 898-5:2012(IDT)