SS-ENV-13999-3 › Adhesives - Short term method for measuring the emission properties of low-solvent or solvent-free adhesives after application - Part 3: Determination of volatile aldehydes
Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
This European Prestandard specifies a procedure for the determination of volatile aldehydes (esp. formaldehyde and acetaldehyde) in the exhaust air of an emission test chamber after application of an adhesive. The method is based on chemosorption of volatile aldehydes with 2,4-dinitrophenylhydrazine (in the following: DNPH) impregnated silica tubes or cartridges with subsequent solvent desorption, clean-up and liquid chromatographic analysis. The method permits measurement of several aldehydes including formaldehyde, acetaldehyde, propionaldehyde, butyraldehyde, valeraldehyde, isovaleraldehyde, hexanal, benzaldehyde, 2,5- dimethylbenzaldehyde, o-tolualdehyde, m-tolualdehyde, p-tolualdehyde, crotonaldehyde in the concentration range of approximately 10 µg/m³ to 1 mg/m³ (see ISO 16000-3).
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Designation Name
SS-ENV 13999-3
Revision Level
EDITION 1
Status
Superseded
Publication Date
Dec. 20, 2002
Language(s)
English
Page Count
11
International Equivalent
ENV 13999-3:2002 IDT