SS-ISO-10508 Plastics piping systems for hot and cold water installations - Guidance for classification and design (ISO 10508:2006, IDT)

SS-ISO-10508 - 2006 EDITION - CURRENT


Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:


This International Standard gives guidance for the classification and design of hot and cold water pressure systems which use plastics pipes and plastics or metal fittings. It establishes a classification system for common service conditions for pressurized hot and cold water systems. It gives a basis for evaluation and design of thermoplastics pipes and fittings in relation to the system performance requirements. It applies to plastics piping systems used to carry water a) in distribution systems of hot and cold water, including potable water, and b) in transportation systems of hot water for heating, under design pressures up to at least 10 bar 1) at 20 °C and up to 10 bar at temperatures according to the class of application (see Table 1). For values of TD, Tmax and Tmal in excess of those in Table 1, this International Standard is not applicable. Acceptance of any pipe(s) and/or fitting(s) made from a specific grade of material is subject to the relevant product or systems standard and the requirements detailed there. 1) 1 bar = 0,1 MPa = 105 Pa; 1 MPa = 1 N/mm2.

To find similar documents by classification:

23.040.20 (Plastics pipes)

23.040.45 (Plastics fittings)

91.140.60 (Water supply systems Including water meters in buildings External water conveyance systems, see 93.025)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

ORDER

Price:

$86.25        




Designation Name

SS-ISO 10508:2006

Revision Level

2006 EDITION

Status

Current

Publication Date

March 24, 2006

Language(s)

English

Page Count

13