SS-ISO-11118 Gas cylinders - Non-refillable metallic gas cylinders - Specification and test methods (ISO 11118:1999, IDT)

Show Complete Document History

Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:

This International Standard specifies minimum requirements for the material, design, construction and workmanship,manufacturing processes and tests at manufacture of non-refillable metallic gas cylinders of welded, brazed orseamless construction for compressed, liquefied and dissolved gases exposed to extreme worldwide ambienttemperatures.NOTE The specific gases permitted in cylinders constructed to this International Standard may be limited by ISO, nationalrequirements or international requirements.This International Standard is applicable to cylinders where:a) the maximum permissible operating pressure does not exceed 250 bar (i.e. pms < 250 bar);b) the product of the maximum permissible operating pressure and the water capacity does not exceed 1 000bar.litres (i.e. pms. V < 1 000 bar.l);c) where the maximum permissible operating pressure exceeds 35 bar, the water capacity does not exceed 5 l(i.e. for pms . 35 bar, then V < 5 l).This International Standard is not applicable to cylinders exceeding these pressure and volume limits, for whichreference may be made to refillable cylinder standards.This International Standard is also not applicable to cartridges/aerosol dispensers1) and spherical containers.

To find similar documents by classification:

23.020.30 (Gas pressure vessels, gas cylinders Steam pressure vessels, see 27.060.30 Steel for pressure purposes, see 77.140.30)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

Designation Name

SS-ISO 11118:2013

Revision Level




Publication Date

Oct. 3, 2013



Page Count


International Equivalent

ISO 11118:1999(IDT)