SS-ISO-11119-3 Gas cylinders - Refillable composite gas cylinders and tubes - Design, construction and testing - Part 3: Fully wrapped fibre reinforced composite gas cylindersand tubes up to 450L with non-load-sharing metallic or non-metallic liners (ISO 11119-3:2013, IDT)

SS-ISO-11119-3 - 2013 EDITION - CURRENT


Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:


This part of ISO 11119 specifies requirements for composite gas cylinders up to 150 l water capacity and composite tubes above 150 l water capacity and up to 450 l water capacity, for the storage and conveyance of compressed or liquefied gases. The cylinders and tubes in this part of ISO 11119 area) Type 4 Fully Wrapped Cylinders or Tubes with a non-load sharing liner and composite reinforcement on both the cylindrical portion and the dome ends, and b) Type 5 Fully Wrapped Cylinders or Tubes without liners (including cylinders without liners manufactured from two parts joined together) and with a test pressure of less than 60 bar. The cylinders are constructed:1) in the form of a disposable mandrel overwrapped with carbon fibre or aramid fibre or glass fibre (or a mixture thereof) in a resin matrix to provide longitudinal and circumferential reinforcement; 2) in the form of two filament wound shells joined together.Cylinders and tubes manufactured and tested to this part of ISO 11119 are not intended to contain toxic, oxidizing or corrosive gases.This part of ISO 11119 is limited to cylinders and tubes with composite reinforcement of carbon fibre or aramid fibre or glass fibre (or a mixture thereof) in a matrix. Cylinders and tubes manufactured and tested to this part of ISO 11119 have a minimum design life of 15 years. This part of ISO 11119 does not address the design, fitting and performance of removable protective sleeves.NOTE 1 References to cylinders in this International Standard include composite tubes if appropriate. NOTE 2 ISO 11439 applies to cylinders intended for use as fuel containers on natural gas vehicles and ISO 11623 covers periodic inspection and re-testing of composite cylinders.

To find similar documents by classification:

23.020.30 (Gas pressure vessels, gas cylinders Steam pressure vessels, see 27.060.30 Steel for pressure purposes, see 77.140.30)

23.020.35 (Gas cylinders)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

ORDER

Price:

$153.75        


Want this as a site license?



Designation Name

SS-ISO 11119-3:2013

Revision Level

2013 EDITION

Status

Current

Publication Date

April 26, 2013

Language(s)

English

Page Count

56

International Equivalent

ISO 11119-3:2013(IDT)