SS-ISO-12151-2 › Connections for hydraulic fluid power and general use Hose fittings Part 2: Hose fittings with ISO 8434-1 24° cone connector ends with O-rings (12151-2:2022, IDT)
Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
This document specifies the general and dimensional requirements for the design and performance of hose fittings with 24° cone connector ends with O-rings according to ISO 8434-1. These hose fittings are made of carbon steel and are intended for use with hoses with nominal inside diameters from 5 mm through 38 mm (inclusive). NOTE For hose fittings used in hydraulic and pneumatic braking systems on road vehicles, see ISO 4038, ISO 4039-1 and ISO 4039-2. These hose fittings are for use in hydraulic fluid power systems with hoses that meet the requirements of respective hose standards and in general applications with suitable hoses.
To find similar documents by classification:
23.040.70 (Hoses and hose assemblies)
23.100.40 (Piping and couplings)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Designation Name
SS-ISO 12151-2:2023
Revision Level
2023 EDITION
Status
Current
Publication Date
Dec. 7, 2023
Language(s)
English
Page Count
24
International Equivalent
ISO 12151-2:2022