SS-ISO-128-50 › Technical drawings - General principles of presentation - Part 50: Basic conventions for representing areas on cuts and sections
Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
This part of ISO 128 specifies general principles for representing areas on cuts and sections on technical drawings (mechanical, electrical, architectural, civil-engineering etc.) following the orthographic projection methods specified in ISO 5456-2. Attention has also been given to the requirements of reproduction, including microcopying in accordance with ISO 6428. NOTE The basic rules for cuts and sections are given in ISO 128-40 [1] .
To find similar documents by classification:
01.100.01 (Technical drawings in general)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Designation Name
SS-ISO 128-50
Revision Level
EDITION 1
Status
Superseded
Publication Date
May 11, 2001
Language(s)
English
Page Count
8
International Equivalent
ISO 128-50:2001 IDT