SS-ISO-14743 › Pneumatic fluid power - Push-in connectors for thermoplastic tubes (ISO 14743:2020, IDT)
Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
This document specifies the general requirements and test methods for the design and performance of push-in connectors for use with thermoplastic tubes with outside diameters (OD) from 3 mm to 16 mm including dimensions in inches. This document is intended to establish uniform methods of testing complete push-in connector assemblies as used in pneumatic fluid power applications. It is not applicable to air braking systems.
To find similar documents by classification:
23.100.40 (Piping and couplings)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Designation Name
SS-ISO 14743:2020
Revision Level
2020 EDITION
Status
Current
Publication Date
Jan. 15, 2020
Language(s)
English
Page Count
40
International Equivalent
ISO 14743:2020(IDT)