SS-ISO-15407-2 › Pneumatic fluid power - Five-port directional control valves, sizes 18 mm and 26 mm - Part 2: Mounting interface surfaces with optional electrical connector
SS-ISO-15407-2
-
EDITION 1
-
CURRENT
Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
This part of ISO 15407 specifies the following requirements for a mounting interface and electrical connector for five-port pneumatic directional control valves, sizes 18 mm and 26 mm, for use at a maximum rated pressure of 1,6 MPa [16 bar]: - dimensions and tolerances of the interface features; - port identification; - identification of the result of control-mechanism actuation; - dimensions, tolerances and specifications for optional interface electrical connector mateability. It is not applicable to the functional characteristics of interfaces. NOTE The requirements for mounting interfaces of five-port directional control valves, sizes 18 mm and 26 mm, without electrical connector are specified in ISO 15407-1.
To find similar documents by classification:
23.100.50 (Control components Including valves)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Designation Name
SS-ISO 15407-2
Revision Level
EDITION 1
Status
Current
Publication Date
May 28, 2003
Language(s)
English
Page Count
12
International Equivalent
ISO 15407-2:2003 IDT