SS-ISO-21018-3 › Hydraulic fluid power - Monitoring the level of particulate contamination of the fluid - Part 3: Use of the filter blockage technique (ISO 21018-3:2008, IDT)
SS-ISO-21018-3
-
2011 EDITION
-
CURRENT
Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
This part of ISO 21018 specifies a method for the semi-quantitative determination of the particulate contamination level using the filter blockage technique (also known as the mesh-obscuration method or the pore-blockage technique) either on-line or off-line in containers. It also defines procedures for calibrating the instruments and verifying their correct operation both in the laboratory and in service. In general, the techniques described in this part of ISO 21018 are suitable for monitoring a) the general cleanliness level in hydraulic systems, b) the progress in flushing operations, c) support equipment and test rigs. The use of this method is applicable to all single- or multi-phase liquid systems.
To find similar documents by classification:
23.100.60 (Filters, seals and contamination of fluids Hydraulic fluids, see 75.120)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Designation Name
SS-ISO 21018-3:2011
Revision Level
2011 EDITION
Status
Current
Publication Date
Sept. 15, 2011
Language(s)
English
Page Count
32
International Equivalent
ISO 21018-3:2008(IDT)