SS-ISO-248-1 › Rubber, raw - Determination of volatile-matter content - Part 1: Hot-mill method and oven method (ISO 248-1:2011, IDT)
SS-ISO-248-1
-
2011 EDITION
-
CURRENT
Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
1.1 This part of ISO 248 specifies two methods for the determination of volatile-matter content in raw rubbers by using a hot mill or an oven. 1.2 The methods are applicable to the determination of the volatile-matter content in the R group of rubbers listed in ISO 1629. These are rubbers having an unsaturated carbon chain, for example natural rubber and synthetic rubbers derived at least partly from diolefins. The methods can also be applicable to other raw rubbers, but in these cases it is necessary to demonstrate that the change in mass is due solely to loss of actual volatile matter and not to rubber degradation. 1.3 The hot-mill method is not applicable to natural rubber, to synthetic rubbers which are too difficult to handle on a hot mill or to synthetic rubbers in powder or chip form. 1.4 The test methods do not necessarily give identical results. Therefore, in cases of dispute, the oven method, procedure A, is the reference method. NOTE The applicability of each test method to various types of rubber is summarized in Annex A.
To find similar documents by classification:
83.040.10 (Latex and raw rubber)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Designation Name
SS-ISO 248-1:2011
Revision Level
2011 EDITION
Status
Current
Publication Date
Nov. 24, 2011
Language(s)
English
Page Count
24
International Equivalent
ISO 248-1:2011(IDT)