SS-ISO-2942 › Hydraulic fluid power - Filter elements - Verification of fabrication integrity and determination of the first bubble point (ISO 2942:2004, IDT)
SS-ISO-2942
-
2004 EDITION
-
CURRENT
Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
This International Standard specifies a bubble-point test method applicable to filter elements used in hydraulic fluid power systems. It can be used either to verify the fabrication integrity of a filter element (by checking the absence of bubbles) or to permit the localization of the largest pore of the filter element by determining the first bubble point. Verification of fabrication integrity defines the acceptability of the filter elements for further use or testing. The first bubble point is established through continuation of the fabrication integrity test. It is under no circumstances a functional characteristic of a filter element; in particular, it cannot be used for extrapolation to the concepts of filtration rating, efficiency or retention capacity and should be used for information only.
To find similar documents by classification:
23.100.60 (Filters, seals and contamination of fluids Hydraulic fluids, see 75.120)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Designation Name
SS-ISO 2942:2004
Revision Level
2004 EDITION
Status
Current
Publication Date
Oct. 8, 2004
Language(s)
English
Page Count
11
International Equivalent
ISO 2942:2004(IDT)