SS-ISO-3511-3 › Process measurement control functions and instrumentation - Symbolic representation - Part 3: Detailed symbols for instrument interconnection diagrams
SS-ISO-3511-3
-
EDITION 1
-
CURRENT
Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
This part of IS0 3511 specifies instrument symbols for use on interconnection diagrams used for the design, installation, and maintenance of process measurement and control systems. These detailed symbols are not normally intended for drawings that use the functional symbols given in IS0 3511 /l and IS0 3511/2. However, the symbols specified in this part of IS0 3511 show, by detailing the components, the external connections between units of equipment. Information on the internal connections in units is not normally included, but references to the appropriate circuit or wiring diagrams may be provided. When an instrument is composed of more than one functional part, the different symbols may be combined, for example, recorder controller. The dimensions of the symbols are unspecified, provided the ratio of the side lengths is maintained according to this part of IS0 3511.2) If not otherwise stated, contact symbols should be shown open. The diagrams may employ single line or multi-line representation and may be combined with, or replaced by tables, providing clarity is maintained. For further assistance, see IEC Publication 113 Part 5, Preparation of interconnection diagrams and tables.
To find similar documents by classification:
25.040.40 (Industrial process measurement and control)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Designation Name
SS-ISO 3511-3
Revision Level
EDITION 1
Status
Current
Publication Date
June 6, 1990
Language(s)
English, Swedish
Page Count
36
International Equivalent
ISO 3511-3:1984(IDT)