SS-ISO-8779 Plastics piping systems - Polyethylene (PE) pipes for irrigation - Specifications (ISO 8779:2010, IDT)

SS-ISO-8779 - 2010 EDITION - CURRENT
Show Complete Document History

Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:

Included in this current edition are the following subparts:

 2010 EDITION - March 29, 2010
 2010/Amd 1:2014 EDITION AMENDMENT - July 4, 2014

This International Standard specifies the pipes (mains, sub-mains and laterals) with nominal outside diameters from 12 mm up to and including 63 mm made from polyethylene (PE) intended to be used for the conveyance of water for irrigation. It also specifies the general properties of PE and the test parameters for the pipes designated as PE 32 and PE 40 by checking referenced points as given in 4.4, to be used under the following conditions: - nominal pressures of PN 2,5, PN 4, PN 6, PN 8 and PN 10, as applicable, - at temperatures up to and including 45 ÂșC, as specified in Annex A. NOTE Pipes with a diameter of 75 mm and nominal pressure (PN) of 4 bar1) are also included in this International Standard.

To find similar documents by classification:

23.040.20 (Plastics pipes)

65.060.35 (Irrigation and drainage equipment)

83.140.30 (Plastics pipes and fittings for non fluid use Plastics pipes, fittings and valves for general use, see 23.040.20, 23.040.45 and 23.060)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

ORDER

Price:

$206.21        




Designation Name

SS-ISO 8779:2010

Revision Level

2010 EDITION

Status

Current

Publication Date

March 29, 2010

Language(s)

English

Page Count

28

International Equivalent

ISO 8779:2010(IDT)