SS-ISO-9409-1 › Manipulating industrial robots - Mechanical interfaces - Part 1: Plates (ISO 9409-1:2004, IDT)
Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
This part of ISO 9409 defines the main dimensions, designation and marking for a circular plate as mechanical interface. It is intended to ensure the exchangeability and to keep the orientation of hand-mounted end effectors. This part of ISO 9409 does not define other requirements of the end effector coupling device. This part of ISO 9409 does not contain any correlation of load-carrying ranges, as it is expected that the appropriate interface is selected depending on the application and the load-carrying capacity of the robot. The mechanical interfaces specified in this part of ISO 9409 will also find application in simple handling systems which are not covered by the definition of manipulating industrial robots, such as pick-and-place or master-slave units.
To find similar documents by classification:
25.040.30 (Industrial robots. Manipulators)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Designation Name
SS-ISO 9409-1:2012
Revision Level
2012 EDITION
Status
Current
Publication Date
March 26, 2012
Language(s)
English
Page Count
20
International Equivalent
ISO 9409-1:2004(IDT)