ASTM-B501 › Standard Specification for Silver-Coated, Copper-Clad Steel Wire for Electronic Application
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This specification covers silver-coated, round, copper-clad steel wire for electronic application.
1.2 Silver coatings in mass percentages of the total mass of the coated wire are as follows: 1.25, 2.5, 4.0, 6.1, and 8.0.
1.2.1 Silver-coated wire having different minimum percentage of silver by mass may be obtained by mutual agreement between the manufacturer and the purchaser. For information purposes, the thickness of coating in microinches provided by the mass percentages listed in 1.2 is shown in Table 1.
1.3 Four classes of copper-clad steel wire are covered as follows: Class 30HS nominal 30% conductivity hard-drawn, Class 30A nominal 30% conductivity annealed, Class 40HS nominal 40% conductivity hard-drawn, and Class 40A nominal 40% conductivity annealed.
1.4 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only except for resistivity, where the SI units are to be regarded as the standard.
1.5 The following safety hazards caveat pertains to the test method described in this specification. This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. See Explanatory Note 1.
Keywords
Clad steel electrical conductor (copper); Coating continuity; Coating weight; Copper-clad steel electrical conductors; Electrical conductors-copper; Electronic materials/applications-Cu/Cu alloys; Hard-drawn aluminum-clad steel wire; Silver-electrical/electronic applications; Silver-coated copper wire; Silver content; Sodium polysulfide test-coating continuity; Steel wire-copper-clad; silver-coated copper-clad steel (electronic) wire, spec; ICS Number Code 29.060.10 (Wires)
To find similar documents by ASTM Volume:
To find similar documents by classification:
29.060.10 (Wires Including electric rods, busbars, etc.)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Customers who bought this document also bought:
MIL-DTL-17Cables, Radio Frequency, Flexible and Semirigid, General Specification for
QPL-17
Cables, Radio Frequency, Flexible and Semirigid, General Specification for
ASTM-B545
Standard Specification for Electrodeposited Coatings of Tin
Document Number
ASTM-B0501-10R19
Revision Level
2010 R19 EDITION
Status
Current
Modification Type
Revision
Publication Date
Oct. 1, 2019
Document Type
Specification
Page Count
5 pages
Committee Number
B01.06