ASTM-B624 › Standard Specification for High-Strength, High-Conductivity Copper-Alloy Wire for Electronic Application
The following bibliographic material is provided to assist you with your purchasing decision:
This specification covers high-strength, high conductivity round copper-alloy wire used for electronic hook-up wire. The wires shall conform to the required minimum breaking strength and elongation. Electrical resistance and diameter of the wire shall be measured. The finished material shall be free of defects that detract from the normal end use or longevity of the product. Joints necessary to processing shall be of such quality that all requirements are met.
Scope
1.1 This specification covers high-strength, high-conductivity round copper-alloy wire 0.00099 to 0.0720 in. [0.025 to 1.829 mm] in diameter, used for electronic hookup wire. The tensile strength of the wire is 60 ksi [414 MPa] minimum and the electrical conductivity at 20°C is 85 % IACS minimum.
1.2 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Keywords
ICS Number Code 29.060.10 (Wires)
To find similar documents by ASTM Volume:
To find similar documents by classification:
29.060.10 (Wires Including electric rods, busbars, etc.)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Customers who bought this document also bought:
MIL-STD-202Test Method Standard for Electronic and Electrical Component Parts
ASTM-D2671
Standard Test Methods for Heat-Shrinkable Tubing for Electrical Use
MIL-STD-104
Limit for Electrical Insulation Color
Document Number
ASTM-B624-07(2017)
Revision Level
2007 R17 EDITION
Status
Current
Modification Type
Reapproval
Publication Date
Sept. 1, 2017
Document Type
Specification
Page Count
4 pages
Committee Number
B01.04