Document Center is acquired by Nimonik

Scope

1.1 These test methods cover the determination of the specific gravity of water and brine free of separable oil, as follows:

Sections Test Method A-Pycnometer 7 to 11 Test Method B-Balance 12 to 16 Test Method C-Erlenmeyer Flask 17 to 20 Test Method D-Hydrometer 21 to 25

1.2 Test Methods A and B are applicable to clear waters or those containing only a moderate amount of particulate matter. Test Method B is preferred for samples of sea water or brines and is more sensitive than Test Method D which has the same general application. Test Method C is intended for samples of water containing mud or sludge.

1.3 It is the user's responsibility to ensure the validity of these test methods for waters of untested matrices.

1.4 The test method was tested at 22°C over a range, shown in Tables 1 through 4, of 1.0252 through 1.2299; all data were corrected to 15.6°C (60°F).

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

Brackish water/brines; Specific gravity; specific gravity-water/brine, test; ICS Number Code 13.060.50 (Examination of water for chemical substances)

To find similar documents by ASTM Volume:

11.01 (Water (I))

To find similar documents by classification:

13.060.50 (Examination of water for chemical substances)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.