Document Center is acquired by Nimonik

Scope

1.1 This test method is intended as a rapid method for the evaluation of the oxidation stability of new mineral insulating oils containing a synthetic oxidation inhibitor. This test is considered of value in checking the oxidation stability of new mineral insulating oils containing 2,6-ditertiary-butyl para-cresol or 2,6-ditertiary-butyl phenol, or both, in order to control the continuity of this property from shipment to shipment. The applicability of this procedure for use with inhibited insulating oils of more than 12 cSt at 40°C (approximately 65 SUS at 100°F) has not been established.

1.2 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of whoever uses this standard to consult and establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Note 1—A modification of this test method which uses the same procedure and apparatus but a higher (150°C) bath temperature has been published as Test Method D2272.

Keywords

electrical; inhibitor; insulating oil; mineral oil; oxidation stability; rotating vessel; transformer oil; ICS Number Code 29.040.10 (Insulating oils)

To find similar documents by ASTM Volume:

10.03 (Electrical Insulating Liquids and Gases; Electrical Protective Equipment)

To find similar documents by classification:

29.040.10 (Insulating oils)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.