ASTM-D3713 › Standard Test Method for Measuring Response of Solid Plastics to Ignition by a Small Flame (Withdrawn 2000)
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This is a fire-test-response standard.
1.2 This test method covers a small-scale procedure for characterizing the response of a plastic to an ignition source consisting of a small flame of controlled intensity applied to the base of a standard sample being held in a vertical position.
1.3 This standard should be used to measure and describe the reponse of materials, products, or assemblies to heat and flame under controlled conditions and should not be used to describe or appraise the fire hazard or fire risk of materials, products, or assemblies under actual fire conditions. However, results of this test may be used in a fire hazard assessment or a fire risk assessment which takes into account all of the factors which are pertinent to an assessment of the fire hazard or fire risk of a particular end use.
1.4 The values stated in SI units are to be regarded as the standard.
Note 1-See Method D3801 which, unless otherwise specified, uses the same specimens for measuring the comparative extinguishing characteristics of solid plastics when tested in a vertical position.1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific hazard statements are given in 10.1.
Note 2-There is no similar or equivalent ISO standard.Keywords
Fire-test-response standard; Flammability-plast; Ignition-plast; Plast (electrical insulating); Plast (general); Small-scale burning tests; response of solid plast to ignition by small flame, test,; Vertical position; response of solid plast to ignition by small flame,test
To find similar documents by ASTM Volume:
08.02 (Plastics (II): D3222 - D5083)
To find similar documents by classification:
83.080.01 (Plastics in general)
This document comes with our free Notification Service, good for the life of the document.
This document is available in Paper format.
Customers who bought this document also bought:
IPC-R-700Modification, Rework & Repair of Printed Boards & Assemblies
IPC-A-610
Acceptability of Electronic Assemblies (Hardcopy format)
EIA-568
Commercial Building Telecommunications Cabling Standard
Document Number
ASTM-D3713-95
Revision Level
1995 EDITION
Status
Superseded
Modification Type
Withdrawn
Publication Date
Feb. 15, 1995
Document Type
Test Method
Page Count
7 pages
Committee Number
D20.30