ASTM-D4474 › Standard Classification System for Styrenic Thermoplastic Elastomer Injection Molding and Extrusion Materials (TES) (Withdrawn 2008)
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This classification and subsequent line callout (specification) cover styrenic block copolymer thermoplastic elastomer materials for injection molding and extrusion. Copolymers consist of polystyrene segments bound to rubbery segments. The rubbery segments may be saturated or unsaturated. Compounding ingredients may be present as necessary for the application. The compounding ingredients may consist of reinforcements, resins, plasticizers, fillers, stabilizers, and colorants. Recycled styrenic thermoplastic elastomers are not covered in this classification.
1.2 The properties included in this classification are those required to identify the compositions covered. There may be other requirements necessary to identify particular characteristics that are important to specialized applications. These may be described by using the suffixes specified in Section 5.
1.3 The values stated in SI units, as detailed in IEEE/ASTM SI 10, are to be regarded as the standard.
Note 1--There is no equivalent ISO standard.
Keywords
line callout; plastic; styrenic; thermoplastic elastomer; ICS Number Code 83.060 (Rubber)
To find similar documents by ASTM Volume:
08.02 (Plastics (II): D3222 - D5083)
To find similar documents by classification:
83.060 (Rubber Raw rubber, see 83.040.10)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D4474-00
Revision Level
2000 EDITION
Status
Cancelled
Modification Type
Withdrawn
Publication Date
Nov. 10, 2000
Document Type
Classification
Page Count
5 pages
Committee Number
D20.15