ASTM-D4550 › Standard Specification for Thermoplastic Elastomer-Ether-Ester (TEEE) (Withdrawn 2004)
Show Complete Document History
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This specification covers segmented block copolyether-ester elastomers suitable for molding and extrusion.
1.2 The properties included in this specification are those required to identify the compositions covered. There may be other requirements necessary to identify particular characteristics important to specialized applications. These shall be agreed upon between the user and the supplier, by using the suffixes given in Section 5.
1.3 The values stated in SI units are to be regarded as the standard.
1.4 The following precautionary caveat pertains only to the test methods portion, Section 12 of this specification: This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
Blowmolding; Elastomeric materials; Ether-ester (TEEE) elastomers; Fabrication; Material properties; Molding/extrusion compounds/materials; Plast (general)-specifications; Plast (thermoplastic); Polyether-ester elastomers; Thermoforming; Thermoplastic elastomers; thermoplastic elastomer-ether-ester (TEEE), spec; ICS Number Code 83.060 (Rubber)
To find similar documents by ASTM Volume:
08.02 (Plastics (II): D3222 - D5083)
To find similar documents by classification:
83.060 (Rubber Raw rubber, see 83.040.10)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D4550-98
Revision Level
1998 EDITION
Status
Cancelled
Modification Type
Replaced
Publication Date
March 10, 1998
Document Type
Specification
Page Count
7 pages
Committee Number
D20.15