ASTM-D7707 › Historical Revision Information
Standard Specification for Wipe Sampling Materials for Beryllium in Surface Dust
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This specification covers requirements for premoistened wipe materials that are used to collect settled dusts on surfaces for the subsequent determination of beryllium.
1.2 For wipe materials used for the determination of lead in surface dust, refer to Specification E1792. This is mentioned to insure that users of wipes recognize that there is some relationship between wipes and the analyte of interest.
1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.4 This specification contains notes that are explanatory and are not part of the mandatory requirements of the specification.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
beryllium; surface dust; wipe;
To find similar documents by ASTM Volume:
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D7707-11(2016)
Revision Level
2011 R16 EDITION
Status
Superseded
Modification Type
Reapproval
Publication Date
Oct. 15, 2016
Document Type
Specification
Page Count
3 pages
Committee Number
D22.04