ASTM-F1796 › Historical Revision Information
Standard Specification for High Voltage Detectors - Part 1 Capacitive Type to be Used for Voltages Exceeding 600 Volts AC
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This specification covers portable, live-line tool-supported, direct-contact type capacitive voltage detectors to be used on electrical systems both indoors and outdoors for ac voltages from 600 V to 800kV with frequency of 60 Hz. The function of the voltage detector is limited to the detection of the presence or absence of nominal operating voltage.
1.1.1 This specification is not applicable to other types of voltage detectors.
1.2 The use and maintenance of these high voltage detectors and any necessary insulated tool handles are beyond the scope of this specification.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
To find similar documents by ASTM Volume:
10.03 (Electrical Insulating Liquids and Gases; Electrical Protective Equipment)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-F1796-97
Revision Level
1997 EDITION
Status
Superseded
Modification Type
Editorially changed
Publication Date
April 10, 1997
Document Type
Specification
Page Count
6 pages
Committee Number
F18.35