Document Center is acquired by Nimonik

Scope

1.1 This specification covers round wire up to 0.006 in. (0.15 mm) in diameter for use as electron tube grid lateral winding wire.

1.2 Five classes of wire are covered based on their tensile properties (see 5.2 and 5.3).

1.3 The values stated in inch-pound units are to be regarded as the standard. The metric equivalents of inch-pound units may be approximate.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

Electrical conductors-wire (for electronic devices); Electron tubes-wire; Grid laterals; Metals and metallic materials-electronic components/devices; Molybdenum-electronic applications; Nickel alloys-electronic applications; Nickel-manganese alloy; Nickel-molybdenum-iron alloy; Nickel-titanium-magnesium alloy; Small diameter wire; Tungsten-electronic applications; Wire-electronic devices; UNS N02211 (nickel alloy, solution strengthened, Nickel 211); UNS N03300 (Ni alloy, Permanickel 300); UNS N10001 (Ni-Mo alloy, Hastelloy B); UNS R07005 (tungsten); round wire ([∧lt;=]0.006 in. (0.15 mm))-winding electron tube grid; side laterals, spec; ICS Number Code 29.060.10 (Wires)

To find similar documents by ASTM Volume:

10.04 (Electronics; Declarable Substances in Materials; 3D Imaging Systems)

To find similar documents by classification:

29.060.10 (Wires Including electric rods, busbars, etc.)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.