MIL-STD-105 Sampling Procedures and Tables for Inspection by Attributes (See Cancellation Notice 3 for Additional Information)

MIL-STD-105 - REV E CANCELLATION 3 - CANCELLED -- See the following: ASQ-Z1.4 MIL-STD-1916
Show Complete Document History


Sampling Procedures and Tables for Inspection by Attributes (See Cancellation Notice 3 for Additional Information)

Scope

1.     SCOPE

1.1  Purpose.  This publication establishes lot of batch sampling plans and procedures for inspection by attributes.  This publication shall not be interpreted to supercede or conflict with any contractual requirements.  The words "accept", "acceptance", "acceptable", etc, refer only to the contractor's use of the sampling plans contained in this standard and do not imply an agreement by the Government to accept any product.  Determination of acceptability by the Government shall be as described in contractual documents.  The sampling plans described in this standard are applicable to AQL's of .01 percent or higher and are therefore not suitable for applications where quality levels in the defective parts per million range can be realized.

Notes

Claudia's Notes:
There are three cancellation notices for the MIL-STD-105.  The last, in February of 2008, provided the user with two replacement documents:  The MIL-STD-1916 and ASQ-Z1.4.  Both of the replacement documents, as well as the obsolete MIL-STD-105E with cancellation notice 3, are available from Document Center Inc. if you need them.


To find similar documents by Federal Supply Class Code:

FSC Standardization Area QCIC (Quality Control/Assurance and Inspection)

ORDER



Document Number

MIL-STD-105

Revision Level

REV E CANCELLATION 3

Status

Cancelled

Publication Date

Feb. 6, 2008

Page Count

1 page