ASTM-D709 › Historical Revision Information
Standard Specification for Laminated Thermosetting Materials
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This specification covers laminated thermosetting materials consisting of two or more plies or layers of reinforcing material bonded by a thermosetting synthetic resin. Examples of such reinforcement are cellulose paper, cotton fabric, glass fabric, and synthetic fiber fabrics. These materials are available in the form of sheets, rolled and molded tubes, and molded rods.
1.2 The values stated in inch-pound units are to be regarded as the standard.
Note 1—This specification resembles IEC 60893-3 in title only. The content is significantly different.1.3 The following safety hazards caveat pertains only to the test methods described in this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
industrial laminate; thermosetting molded shape laminate; thermosetting round rod laminate; thermosetting sheet laminate; thermosetting tube laminate; ICS Number Code 91.100.40 (Products in fibre-reinforced cement)
To find similar documents by ASTM Volume:
10.01 (Electrical Insulation (I): D69 - D2484)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D709-92
Revision Level
1992 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
Jan. 1, 1992
Document Type
Specification
Page Count
35 pages
Committee Number
D09.07