ASTM-F205 › Standard Test Method for Measuring Diameter of Fine Wire by Weighing
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers the measurement of the average diameter of fine wire by weighing a known length; it applies particularly to sizes up to 0.13 mm (0.005 in.) used in electron devices and lamps.
1.2 The values stated in SI units are to be regarded as the standard. The values given in inch-pound units apply only for the diameter.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
electronic devices; fine wire; wire bonding; ICS Number Code 29.060.10 (Wires)
To find similar documents by ASTM Volume:
10.04 (Electronics; Declarable Substances in Materials; 3D Imaging Systems)
To find similar documents by classification:
29.060.10 (Wires Including electric rods, busbars, etc.)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Customers who bought this document also bought:
IPC-A-610Acceptability of Electronic Assemblies (Hardcopy format)
MIL-STD-883
Microcircuits
ASTM-D638
Standard Test Method for Tensile Properties of Plastics
Document Number
ASTM-F0205-94R20
Revision Level
1994 R20 EDITION
Status
Cancelled
Modification Type
Reapproval
Publication Date
May 15, 2020
Document Type
Test Method
Page Count
4 pages
Committee Number
F01.03