ASTM-A455 › Historical Revision Information
Standard Specification for Pressure Vessel Plates, Carbon Steel, High-Strength Manganese
Show Complete Document History
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This specification covers high-tensile strength carbon-manganese steel plates intended for welded pressure vessels.
1.2 This material is usually made to a semi-killed or capped deoxidation practice. However, at the purchaser's or the producer's option, the material may be made silicon-killed or aluminum-killed.
1.3 The maximum thickness of plates furnished under this specification shall be ¾in. [20 mm].
1.4 For plates produced from coil, the additional requirements, including additional testing requirements and the reporting of additional test results, of Specification A20/A20M apply.
1.5 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the specification.Keywords
pressure vessel steel materials-plates; steel plate-carbon steel; plates-C-Mn steel, high-tensile strength (for welded pressure vessels)
To find similar documents by ASTM Volume:
01.04 (Steel--Structural, Reinforcing, Pressure Vessel, Railway)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-A455-82(1987)
Revision Level
1982 R87 EDITION
Status
Superseded
Modification Type
Editorially changed
Publication Date
July 30, 1982
Document Type
Specification
Page Count
2 pages
Committee Number
A01.11