ASTM-A488 › Historical Revision Information
Standard Practice for Steel Castings, Welding, Qualifications of Procedures and Personnel
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This practice establishes the qualification of procedures, welders, and operators for the fabrication and repair of steel castings by electric arc welding.
1.1.1 Qualifications of a procedure and either or both the operator or welder under Section IX of the ASME Boiler and Pressure Vessel Code shall automatically qualify the procedure and either or both the operator or welder under this practice. P-number designations in the ASME grouping of base metals for qualification may be different than the category numbers listed inTable 1. Refer to Appendix X1 for a comparison of ASTM category numbers with the corresponding ASME P-Number designations.
1.2 Each manufacturer or contractor is responsible for the welding done by his organization and shall conduct the tests required to qualify his welding procedures, welders, and operators.
1.3 Each manufacturer or contractor shall maintain a record of welding procedure qualification tests (Fig. 1), welder or operator performance qualification tests (Fig. 2), and welding procedure specification (Fig. 3), which shall be made available to the purchaser's representative on request.
1.4 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with this practice.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
qualifications; steel castings; welding; ICS Number Code 25.160.10 (Welding processes)
To find similar documents by ASTM Volume:
01.02 (Ferrous Castings; Ferroalloys)
To find similar documents by classification:
25.160.01 (Welding, brazing and soldering in general Including welders' qualifications)
25.160.10 (Welding processes Including thermal cutting and cladding)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-A488-91a
Revision Level
1991A EDITION
Status
Superseded
Modification Type
Revision
Publication Date
Dec. 15, 1991
Document Type
Practice
Page Count
14 pages
Committee Number
A01.18