ASTM-A579 › Historical Revision Information
Standard Specification for Superstrength Alloy Steel Forgings
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This specification covers requirements for forged steel shapes for highly stressed structural members requiring yield strengths in excess of 140 ksi (965 MPa) (0.2% offset).
1.2 This specification is not intended for applications limited by creep deformation.
1.3 Twenty-seven grades are covered by this specification. Selection will depend upon design, service conditions, and mechanical properties required.
1.4 Supplementary requirements are provided for use when additional testing or inspection is desired. These shall apply only when specified individually by the purchaser in the order.
1.5 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.
Keywords
alloy steel forgings; superstrength; ICS Number Code 77.140.85 (Iron and steel forgings)
To find similar documents by ASTM Volume:
01.05 (Steel--Bars, Forgings, Bearing, Chain, Tool)
To find similar documents by classification:
77.140.85 (Iron and steel forgings)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-A579-92(1996)e1
Revision Level
1992 R96(E1) EDITION
Status
Superseded
Modification Type
Revision
Publication Date
July 1, 1997
Document Type
Specification
Page Count
7 pages
Committee Number
A01.06