ASTM-A612 › Historical Revision Information
Standard Specification for Pressure Vessel Plates, Carbon Steel, High Strength, for Moderate and Lower Temperature Service
Show Complete Document History
The following bibliographic material is provided to assist you with your purchasing decision:
This specification covers killed carbon- manganese-silicon steel plates intended for welded pressure vessels in service at moderate and lower temperatures. As a steel making practice, the steel shall be killed and shall conform to specified fine austenitic grain size requirements. Plates are normally supplied in the as-rolled condition. Plates may be ordered normalized or stress relieved, or both. The steel shall conform to the required chemical compositions. The plates, as represented by the tension test specimens, shall conform to the mechanical property requirements.
Scope
1.1 This specification2 covers killed carbon-manganese-silicon steel plates intended for welded pressure vessels in service at moderate and lower temperatures.
1.2 The maximum thickness of plates supplied under this specification is 1 in. [25 mm].
1.3 For plates produced from coil and furnished without heat treatment or with stress relieving only, the additional requirements, including additional testing requirements and the reporting of additional test results, of Specification A20/A20M apply.
1.4 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the specification.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Keywords
carbon steel; steel plates for pressure vessels; lower temperature service; high strength steel plates;
To find similar documents by ASTM Volume:
01.04 (Steel--Structural, Reinforcing, Pressure Vessel, Railway)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-A612/A612M-12(2019)
Revision Level
2012 R19 EDITION
Status
Superseded
Modification Type
Reapproval
Publication Date
April 1, 2019
Document Type
Specification
Page Count
3 pages
Committee Number
A01.11