ASTM-A645 › Standard Specification for Pressure Vessel Plates, 5 % and 51 2 % Nickel Alloy Steels, Specially Heat Treated
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This specification covers austenitized, quenched, temperized, and reversion-annealed 5% nickel alloy steel plates intended primarily for welded pressure vessels for service at low or cryogenic temperatures.
1.2 The maximum thickness of plates which can be supplied under this specification is limited only by the capacity of the material to meet the specified requirements.
1.3 This material is susceptible to magnetization. Use of magnets in handling after heat treatment should be avoided if residual magnetism would be detrimental to subsequent fabrication or service.
1.4 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the specification.
Keywords
alloy steel plate; nickel alloy steel; pressure containing parts; pressure vessel steels; steel plates; steel plates for pressure vessel applications; ICS Number Code 77.140.30 (Steels for pressure purposes); 77.140.50 (Flat steel products and semi-products)
To find similar documents by ASTM Volume:
01.04 (Steel--Structural, Reinforcing, Pressure Vessel, Railway)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-A0645_A0645M-10R22
Revision Level
2010 R22 EDITION
Status
Current
Modification Type
Revision
Publication Date
Sept. 30, 2022
Document Type
Specification
Page Count
4 pages
Committee Number
A01.11