ASTM-A82 › Historical Revision Information
Standard Specification for Steel Wire, Plain, for Concrete Reinforcement, Withdrawn, Replaced by ASTM-A1064
Show Complete Document History
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This specification covers cold-drawn steel wire, as-drawn or galvanized, to be used as such, or in fabricated form, for the reinforcement of concrete, in sizes not less than 2.03 mm (0.080 in.) nominal diameter.
1.2 Supplement S1 describes high-strength wire, which shall be furnished when specifically ordered. It shall be permissible to furnish high-strength wire in place of regular wire if mutually agreed to by the purchaser and the supplier.
1.3 The values stated in either inch-pound units or SI units are to be regarded as standard. Within the text the inch-pound units are shown in parentheses. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values may result in nonconformance with the specification.
Keywords
concrete reinforcement; reinforced concrete; reinforcing steels; steel wire
To find similar documents by ASTM Volume:
01.04 (Steel--Structural, Reinforcing, Pressure Vessel, Railway)
To find similar documents by classification:
77.140.15 (Steels for reinforcement of concrete)
To find similar documents by Federal Supply Class Code:
FSC 9505 (Wire, Nonelectrical)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-A82
Revision Level
REPLACED BY ASTM-A1064
Status
Superseded
Modification Type
Revision
Publication Date
Nov. 15, 2013
Document Type
Specification
Committee Number
A01.05